...
8. firewall VM Can not ping Gateway of ONAP OOM .-- Why this is piece of investigation . .
tocompare with 20171205
Network Toplogy Example from a successful vFWCL Lab on Openstack /OOM
2. Nothing was done as in doing additional steps .
3. 667 Port was not open on Sink VM in successful vFW Demo case .
1. Network Toplogy Example from a successful vFWCL Lab on Openstack /OOM
2. Nothing was done as in doing additional steps .
3. 667 Port was not open on Sink VM in successful vFW Demo case .
21 Additional Step For vLB/ vDNS on VIO 20171207-
1- for each of the network - create Router in the horizon .
2 . update /etc/resolve.conf in firewall VM to point to external DNS So that VMs can reach out to Open Internet .
3. Check on Horizon under the network to see if the Gateway IP address of the subnet/network is showen as "router:interface"
4 Since we are updating the network given in the sdnc preload - please make sure you login to each VM (Load Balancer VM, DNS VM and PktGen VM )
4.1 Login using tenant network and remove every other network
4.2 once logged into VM update the ip address and cidr files present in /opt/config in each VM
4.3 also update the /etc/network/interfaces files for eth1 , eth2 for DNS and PktGen VM and eth1 ,eth2 , eth3 for Load Balancer VM .
4.4 attach the Network via Horizon to each of these VM for Load Balancer VM , try disabling the v_firewall_install.sh and v_firewall_init.sh after running these script onces .
5. DNS VM and PktGen VM are generally able to ping on Tenant and ONAP OOM network including Robot VM .
6 DNS VM can ping the protected network gateway .
7. PktGen can ping unprotected network gateway .
8. Load Balancer VM Can not ping Gateway of ONAP OOM .-- Why this, is piece of investigation..
22 21 .TODO – Issues faced from step13 to Step18 and workaround used .
21 22.1 Challenges faced
2122.1.1 SDC Sanity Docker keep exiting – Needs to raise a JIRA Ticket for the same .This result into every operation from Portal VID GUI resulting in 500 error or 400 error and no operation succeed .
...
This is works as designed .Non Issue .
21 22.1.2 SDNC VM "root" becomes 100% full this results into container being unstable and keep exiting - JIRA Ticket raised
21 22.1.3 Once the SDC is into Issue of 500 or 400 error - The sevices gets into inconsistent state and that requires creating , distributiing the service all over again including customer creation into AAI .
21 22.1.4 SDNC Login page throwing Error :- "Unable to get database connection :Error :connect ECONNREFUSED 127.0.0.1:3306" . Pls see the screen below
...
TODO - raise a JIRA Ticket for the SDNC Issue .
2122.1.5 SO Complaining about Certificate Error while calling createVfModule . createVfModule fails
...
update-ca-certificates with root inside the mso_testlab docker
2122.1.6 ADD VNF Failes From VID GUI with the error – No Valid Catalogue Entry Specified
...